您的位置: 首页 > 国外标准 > 欧洲通信ETS,I-ETS,PRI-ETSETS >  TS 100 910 V7.5.0  数字蜂窝通信系统(第2+阶段) ; 无线传输和接收( 3GPP TS 05.05版1998年7.9.0版本)
 

TS 100 910 V7.5.0  数字蜂窝通信系统(第2+阶段) ; 无线传输和接收( 3GPP TS 05.05版1998年7.9.0版本)

标准编号:TS 100 910 V7.5.0
分享到:

中文标准名称:数字蜂窝通信系统(第2+阶段) ; 无线传输和接收( 3GPP TS 05.05版1998年7.9.0版本)
英文标准名称:Digital cellular telecommunications system (Phase 2+); Radio Transmission and Reception (3GPP TS 05.05 version 7.9.0 Release 1998)
标准状态:已作废
代替标准号:TS 100 910 V6.8.0 (2002)
被代替标准号:TS 100 910 V7.6.0 (2001)
语言:英文版, 中文版
标准类别:欧洲通信ETS,I-ETS,PRI-ETSETS
中国标准文献分类法(中标分类CCS):
中国标准文献分类法(中标分类CCS):
标准页数:76
标准目录:Document Contents
Intellectual Property Rights
Foreword
Foreword
1 Scope
1.1 References
1.2 Abbreviations
2 Frequency bands and channel arrangement
3 Reference configuration
4 Transmitter characteristics
4.1 Output power
4.1.1 Mobile Station
4.1.2 Base station
4.1.2.1 Additional requirements for PCS 1 900 Base stations (PCS 1 900)
4.2 Output RF spectrum
4.2.1 Spectrum due to the modulation and wide band noise
4.2.2 Spectrum due to switching transients
4.3 Spurious emissions
4.3.1 Principle of the specification
4.3.2 Base Transceiver Station
4.3.3 Mobile Station
4.3.3.1 Mobile Station GSM 900 and DCS 1 800
4.3.3.2 Mobile Station PCS 1 900
4.4 Radio frequency tolerance
4.5 Output level dynamic operation
4.5.1 Base Transceiver Station
4.5.2 Mobile Station
4.6 Phase accuracy
4.7 Intermodulation attenuation
4.7.1 Base transceiver station
4.7.2 Intra BTS intermodulation attenuation
4.7.3 Intermodulation between MS (DCS 1 800 & PCS 1 900 only)
4.7.4 Mobile PBX (GSM 900 only)
5 Receiver characteristics
5.1 Blocking characteristics
5.2 AM suppression characteristics
5.3 Intermodulation characteristics
5.4 Spurious emissions
6 Transmitter/receiver performance
6.1 Nominal Error Rates (NER)
6.2 Reference sensitivity level
6.3 Reference interference level
6.4 Erroneous frame indication performance
6.5 Random access and paging performance at high input levels
6.6 Frequency hopping performance under interference conditions.
Annex A (informative): Spectrum characteristics (spectrum due to the modulation)
Annex B (normative): Transmitted power level versus time
Annex C (normative): Propagation conditions
C.1 Simple wideband propagation model
C.2 Doppler spectrum types
C.3 Propagation models
C.3.1 Typical case for rural area (RAx): (6 tap setting)
C.3.2 Typical case for hilly terrain (HTx): (12 tap setting)
C.3.3 Typical case for urban area (TUx): (12 tap setting)
C.3.4 Profile for equalization test (EQx): (6 tap setting)
C.3.5 Typical case for very small cells (TIx): (2 tap setting)
Annex D (normative): Environmental conditions
D.1 General
D.2 Environmental requirements for the MSs
D.2.1 Temperature (GSM 900 and DCS 1 800)
D.2.1.1 Environmental Conditions (PCS 1 900)
D.2.2 Voltage
D.2.3 Vibration (GSM 900 and DCS 1 800)
D.2.3.1 Vibration (PCS 1 900)
D.3 Environmental requirements for the BSS equipment
D.3.1 Environmental requirements for the BSS equipment
Annex E (normative): Repeater characteristics (GSM 900 and DCS 1800)
E.1 Introduction
E.2 Spurious emissions
E.3 Intermodulation products
E.4 Out of band gain
E.5 Frequency error and phase error
Annex F (normative): Antenna Feeder Loss Compensator Characteristics (GSM 900 and DCS 180...
F.1 Introduction
F.2 Transmitting path
F.2.1 Maximum output power
F.2.2 Gain
F.2.3 Burst transmission characteristics
F.2.4 Phase error
F.2.5 Frequency error
F.2.6 Group delay
F.2.7 Spurious emissions
F.2.8 VSWR
F.2.9 Stability
F.3 Receiving path
F.3.1 Gain
F.3.2 Noise figure
F.3.3 Group delay
F.3.4 Intermodulation performance
F.3.5 VSWR
F.3.6 Stability
F.4 Guidelines (informative)
Annex G: Not Used
Annex H (normative): Requirements on Location Measurement Unit
H.1 TOA LMU Requirements
H.1.1 Void
H.1.2 LMU characteristics
H.1.2.1 Blocking characteristics
H.1.2.2 AM suppression characteristics
H.1.2.3 Intermodulation characteristics
H.1.2.4 Spurious emissions
H.1.3 Time-of-Arrival Measurement Performance
H.1.3.1 Sensitivity Performance
H.1.3.2 Interference Performance
H.1.3.3 Multipath Performance
H.1.4 Radio Interface Timing Measurement Performance
H.2 E-OTD LMU Requirements
H.2.1 LMU Characteristics
H.2.1.1 Blocking characteristics
H.2.1.2 AM suppression characteristics
H.2.1.3 Intermodulation characteristics
H.2.2 Sensitivity and Interference Performance
H.2.2.1 Sensitivity Performance
H.2.2.2 Interference Performance
H.2.2.3 Multipath Performance
Annex I (normative): E-OTD Mobile Station Requirements
I.1 Introduction
I.2 Sensitivity and Interference Performance
I.2.1 Sensitivity Performance
I.2.2 Interference Performance
I.2.3 Multipath Performance
Annex L (informative): Change control history
History
文件格式:纸质版或者PDF电子版(用Acrobat Reader打开)或Word版本doc格式
PDF格式 TS 100 910 V7.5.0 数字蜂窝通信系统(第2+阶段) ;
无线传输和接收( 3GPP TS 05.05版1998年7.9.0版本)
 免费下载 Word格式 TS 100 910 V7.5.0 数字蜂窝通信系统(第2+阶段) ;
无线传输和接收( 3GPP TS 05.05版1998年7.9.0版本)
 免费下载免费标准下载
文件大小:463 KB
添加时间:2015/01/09
 
相关免费标准
 
 
本类标准下载排行
 
 
本类最新免费标准
 
免费标准下载网 |标准分享网 |联系我们
版权所有:www.zbgb5.com